Rep 8.5.3.77 Upper Transport Chute Assembly - Xerox DocuPrint N24 Service Manual

REP 8.5.3.77 Upper Transport Chute Assembly

Parts List on PL 8.5.2.15
Removal
1 Switch off the printer power and disconnect the AC Power Cord.
2 Roll the Finisher away from the printer until it stops.
3 Remove the Stapler Door Inner Cover Assembly (REP 8.5.3.3).
4 Remove the Upper Rear Cover (REP 8.5.3.5).
5 Remove the Transport Motor (REP 8.5.3.74).
6 Perform steps 5, 6, and 7 in the Transport Motor Drive Belt procedure (REP 8.5.3.76).
7 Remove the screw that secures the Upper Transport Chute support arm to the Top Cover
Assembly.
8 Disconnect J838 from the Compiler Bin Exit Sensor, and free the wire harness from the clips that
are located on the Upper Transport Chute Assembly.
9 Remove the screw securing the front of the Upper Transport Chute to the front Finisher frame.
10 Remove the screw securing the rear of the Upper Transport Chute to the rear Finisher frame.
11 Remove the Upper Transport Chute Assembly from the Finisher.
Options
Figure 8.5.3.77a. Upper Transport Chute.
3/99
8-436 DocuPrint N24, N32 and N40 Service Manual