Rep 8.5.3.36 Middle Bin Drive Belts - Xerox DocuPrint N24 Service Manual

Network laser printer
Hide thumbs Also See for DocuPrint N24:
Table of Contents

Advertisement

REP 8.5.3.36 Middle Bin Drive Belts

Parts List on PL 8.5.2.8
Removal
1 Switch off the printer power and disconnect the AC Power Cord.
2 Remove the Harness Cover (REP 8.5.3.8).
3 Remove the Middle Bin Assembly (REP 8.5.3.28).
4 Remove the Middle Bin Rear Cover (REP 8.5.3.29).
5 Remove the Middle Bin Motor (REP 8.5.3.34)
6 Remove the Middle Bin Front Cover (REP 8.5.3.35).
7 Remove the screw securing the Sensor Bracket to the Bin Frame, and remove the Bracket
(Figure 8.5.3.36a).
8 Unhook the Front and Rear Tension Springs from the Tension Plates (Figure 8.5.3.36a).
9 Loosen the screws (two each) securing the Front and Rear Tension Plates to the Bin Frame
(Figure 8.5.3.36a).
10 Remove the two screws securing the Limit Actuator to the Bin Frame, and remove the Actuator
(Figure 8.5.3.36a).
11 Remove the E ring secure the Drive Gear to the shaft, and remove the Drive Gear (Figure
8.5.3.36a).
12 Remove the screws (two each) securing the Front and Rear Belt Clamps to the Bin, and remove
the Clamps (Figure 8.5.3.36a).
13 Remove the Front and Rear Belts (Figure 8.5.3.36a).
Replacement
1 Reinstall the Front and Rear Drive Belts and secure with the Belt Clamps and screws.
2 Reinstall the Tension Springs on the Tension Plates.
3 Ensure the Middle Bin is level within the Middle Bin Assembly. If necessary, skip the belt teeth
over the pulley until the bin is level.
4 Tighten the Tension Plate screws.
5 Reinstall the Drive Gear on the shaft, and use an E-ring to secure the Gear.
6 Reinstall the Limit Actuator on the frame, and use two screws to secure the Actuator.
7 Reinstall the Sensor Bracket on the Bin Frame, ensure the Limit Actuator tab is aligned properly
in the Sensor Bracket. Use screw to secure the Bracket.
8 Reinstall the Middle Bin Motor and Bracket.
9 Reinstall the Middle Bin Front Cover.
10 Reinstall the Middle Bin Rear Cover.
11 Reinstall the Middle Bin Assembly.
12 Reinstall the Harness Cover.
Options
3/99
8-366
DocuPrint N24, N32 and N40 Service Manual

Advertisement

Table of Contents
loading

Table of Contents