Xerox DocuPrint N24 Service Manual page 406

Skew
Observe the System Controller Test Pattern, Measure the dimensions 'A' and 'B' on two
consecutive test patterns and check the following: (Figure 7.33h).
• With a distance of 200mm between points 'A' and 'B', the difference in the
measurements between these two points should be less than +/- 1.54mm in Simplex
and less than +/- 2.0mm in Duplex.
1 The skew on the test patterns meets the specification.
Y N
|
Go to RAP 7.45.
2 The printed test patterns meet the Skew specification. Go to the Skips/Smears checkout on the
next page.
Measure at second
line at each edge.
Repair Analysis Procedures (RAP)
Figure 7.33h. Printer Engine Controller Test Pattern
A
200mm
B
2/2000
7-52 DocuPrint N24, N32, N40, N3225, and N4025