Rep 8.5.3.69 Stapler Assembly - Xerox DocuPrint N24 Service Manual

REP 8.5.3.69 Stapler Assembly

Parts List on PL 8.5.2.14
Removal
1 Switch off the printer power and disconnect the AC Power Cord.
2 Remove the Stapler Door Inner Cover Assembly (REP 8.5.3.3).
3 Reach in front the side and pull the Stapler Assembly to the front of the Finisher.
4 Disconnect J862 from the Stapler Assembly.
5 Release the wire harness clip from the side of the Stapler Assembly.
6 Remove the two screws securing the Stapler Assembly to the Slider Bracket, and remove the
Assembly.
7 Release the wire harness from the wire harness clip near the rear of the Stapler Assembly.
Replacement
1 Position the Stapler Assembly near the Slider Bracket.
2 Route the wire harness through the wire clip near the rear of the Stapler Assembly.
3 Reinstall the Stapler Assembly onto the Slider Bracket, making sure you slide the rear tab of the
Stapler into the cutout in the Slider Bracket.
4 Use two screws to secure the Assembly to the Rail.
5 Reinstall the wire harness clip to the side of the Stapler Assembly.
6 Reconnect J862 to the Stapler Assembly.
7 Reinstall the Stapler Door Inner Cover Assembly.
DocuPrint N24, N32 and N40 Service Manual
Figure 8.5.3.69a. Stapler Assembly.
3/99
8-425 Options