Running A Service Sensor (A/D) Input Test - Xerox DocuPrint N24 Service Manual

5.4.7 Running a Service Sensor (A/D) Input Test

1 Enter Diagnostic Mode (5.4.3).
2 The printer is in Diagnostic Mode.
3 Press [1] to display "Service Sensor (A/D) Input Test".
4 Press [4] to display the 1st test from the Main Menu selection in the table (Table 5.4.7a).
5 Press [1] to scroll up or [5] to scroll down through the menu selection to find the desired Output
Test.
6 Press [4] when the desired Input Test is displayed.
The test will automatically stop after 5 seconds.
7 If the desired test has a sub test then press [5] to scroll through the sub test items.
Press [4] again when the desired sub test is displayed. The test will automatically stop after 5
seconds.
8 Press [2] to return to the start of the Service Sensor (A/D) Input Test.
9 Repeat steps 5 - 7 until all desired Input Tests are complete.
10 When you have finished running the Service Sensor (A/D)Input test, Press [2] to exit to the top of
the Diagnostic Mode or switch off the printer power to exit Diagnostic Mode.
Main Menu Selection
PAPER SIZE SENSOR
General Procedures and Information
Table 5.4.7a. Service Value (A/D) Input Test Table
Sub Menu Selection
SELECT TRAY 1 TRAY NOT INSTALLED = No cassette tray
WITH PAPER = Size of tray
3/99
5-24 DocuPrint N24, N32 and N40 Service Manual
Comment
A3S (SEF)
11x17S (SEF)
8.5X14S (SEF)
8.5X13S (SEF)
8.5X11L (LEF)
A4L (LEF)
7.25X10.5 (LEF)
A5L (LEF)
5.5X8.5L (LEF)