Rep 8.2.3.9 Bins 2 Through 10 - Xerox DocuPrint N24 Service Manual

REP 8.2.3.9 BINs 2 through 10

Parts List on PL 8.2.2.4
Removal
NOTE: This procedure covers the removal and replacement of a single BIN. When removing BINs start
with BIN 1 (REP 8.2.3.7) then proceed to step 1 in this procedure. Remove the BINs sequentially
by repeating the steps in this procedure for each Bin in the Mailbox.
1 Switch off the printer power and disconnect the AC Power Cord.
2 Remove wire stopper.
3 Remove Mailbox Left Cover Assembly (REP 8.2.3.1).
4 Remove the Mailbox Front Cover Assembly (REP 8.2.3.2).
5 Remove the Mailbox Rear Cover Assembly (REP 8.2.3.3).
6 Remove the Mailbox Top Cover Assembly (REP 8.2.3.4).
7 Remove the ACT Cover Assembly (REP 8.2.3.5).
8 Remove BIN 1 Assembly (REP 8.2.3.7).
9 Remove Gate 2 Solenoid (REP 8.2.3.10).
10 Remove the three screws securing BIN 2 to the Mailbox frame (Figure 8.2.3.9a).
11 Slide Bin 2 Drive Pulley out of the Drive Belt (Figure 8.2.3.9a)
12 Pull out on latch arms to release the latch that is securing BIN 2 Assembly to BIN 3 Gate (Figure
8.2.3.9a) and remove BIN 2 Assembly.
DocuPrint N24, N32 and N40 Service Manual
Figure 8.2.3.9a. BINs.
3/99
8-93 Options