Xerox DocuPrint N24 Service Manual page 139

32 Carefully pry up both ends of the plastic Feed Out Chute covering the Take Away Roll. Allow the
chute to rotate down and remove the Chute (Figure 4.2.6j).
33 Remove the screw that secures the metal Feed In Chute Assembly (Figure 4.2.6j).
34 Grasp the Chute Assembly and slide the chute toward the front, then remove (Figure 4.2.6j).
35 From the rear of the assembly, remove the E-ring that secures the gear to the end of the Take
Away Roll Shaft (Figure 4.2.6j).
36 Remove the gear and the spacer located next on the Take Away Roll Shaft (Figure 4.2.6j).
37 Remove the screw that secures the Gear Stopper (Figure 4.2.6j). Remove the Gear Stopper.
38 Release the lock tabs and remove the bearing from the front end of the Take Away Roll Shaft
(Figure 4.2.6j).
39 Slide the Take Away Roll Shaft and the Retard assembly toward the rear until the front of the
shaft is free of the assembly.
DocuPrint N24, N32, N40, N3225, and N4025
Figure 4.2.6i. Spring Support Assembly.
2/2000
4-25 Repair Procedures