Rep 8.5.3.90 In Gate Solenoid Assembly - Xerox DocuPrint N24 Service Manual

Network laser printer

Hide thumbs Also See for DocuPrint N24:

Table of Contents

REP 8.5.3.90 In Gate Solenoid Assembly

Parts List on PL 8.5.2.23

1 Switch off the printer power and disconnect the AC Power Cord.

2 Disconnect the Finisher from the Printer (REP 8.5.3.1).

3 Remove the Transport Assembly (REP 8.5.3.11).

4 Remove the Solenoid wire harness (P256M) from the harness clips (Figure 8.5.3.90a).

5 Remove the two screws securing the Solenoid Assembly to the Bracket, and remove the

Assembly (Figure 8.5.3.90a).

6 Pull the Damper Bracket out of the Solenoid Assembly (Figure 8.5.3.90a).

7 Remove the two screws securing the Solenoid Cover to the Solenoid, hold on to the Solenoid

plunger and remove the Solenoid from the Cover (Figure 8.5.3.90a).

CAUTION The Solenoid plunger is under spring tension and may pop out of the Solenoid when

you remove the Solenoid from the Solenoid Cover.

Figure 8.5.3.90a. In Gate Solenoid Assembly.

DocuPrint N24, N32 and N40 Service Manual

Table of Contents