Xerox DocuPrint N24 Service Manual page 476

Replacement
1 Slide the two bearings, lip facing to the center of the shaft, onto the Exit Roll shaft.
2 Reinstall the Exit Roll Gear to the end of the shaft, and use an E-ring to secure it.
3 Reinstall the Exit Roll shaft, the Gear at the Rear of the Duplex Assembly, into the slot in the
Duplex frame.
4 Slide the shaft so the rubber rollers drop into the cutouts in the Duplex Assembly.
5 Slide the bearings along the shaft and into the cutouts in the Assembly.
6 Rotate the bearings so they fit into the cutouts.
7 Use E-rings at the Front and Rear ends of the Exit Roll shaft to secure the bearings.
8 Reinstall the Duplex Cover.
Options
3/99
8-38 DocuPrint N24, N32 and N40 Service Manual