Xerox DocuPrint N24 Service Manual page 494

7 Open the Inner Chute. Check the Duplex Exit Gate and Gate Spring. The Duplex Exit Gate is in
place on the Inner Chute, the Gate is unbroken, it pivots freely on the Inner Chute, and it has a
spring-action return.
Y N
|
Reinstall the Exit Gate and Spring or replace the Duplex Inner Chute (PL 8.1.2.5).
8 Enter Diagnostic Mode - Output Test, Duplex Operation (Exit Gate Solenoid to check the Duplex
Exit Gate function. The Duplex Exit Gate Solenoid toggles the Exit Gate when you start the
Output Test, and it toggles the Exit Gate in the other direction when the Output Test stops.
Y N
|
Realign the Exit Gate Solenoid plunger with the fork at the end of the Gate, or replace the
Inner Chute Assembly (PL 8.1.2.5).
9 Replace the Duplex PWB (REP 8.1.3.5). The problem still exists.
Y N
|
Problem resolved.
10 Go to RAP 8.1.7.3.
Options
3/99
8-56 DocuPrint N24, N32 and N40 Service Manual