Xerox DocuPrint N24 Service Manual page 478

Replacement
1 Position the Sensor on the Bracket so the P/J on the Sensor is to the left.
2 Press the four latches on the bottom of the Sensor into the four openings in the Bracket.
The Sensor snaps into place.
3 Reconnect the P/J to the Sensor.
4 Slide the Sensor actuator through the slot in the Duplex Module, and slide the two arms of the
Sensor Bracket under the tabs next to the actuator slot.
5 Use one screw to secure the Bracket to the Duplex Module.
6 Reinstall the Duplex Cover.
Options
3/99
8-40 DocuPrint N24, N32 and N40 Service Manual