Rep 8.5.3.56 End Wall Motor - Xerox DocuPrint N24 Service Manual

REP 8.5.3.56 End Wall Motor

Parts List on PL 8.5.2.16
Removal
1 Switch off the printer power and disconnect the AC Power Cord.
2 Remove the Stapler Door Inner Cover Assembly (REP 8.5.3.3).
3 Remove the Unload While Run Switch (REP 8.5.3.54).
4 Remove the two screws securing the Harness Holder to the Finisher frame (Figure 8.5.3.56a).
Push the Holder out of the way.
5 Remove the End Wall Spring (Figure 8.5.3.56a).
6 Remove the two screws securing the End Wall Motor Bracket to the Finisher frame (Figure
8.5.3.56a). Remove the Bracket along with the Attached End Wall Motor.
7 Release the End Wall Motor wire harness from the harness clips (Figure 8.5.3.56a).
8 Disconnect the End Wall Motor wire harness at the back of the motor or disconnect P868 (Figure
8.5.3.56a).
9 Remove the two screws securing the End Wall Motor to the Bracket, and remove the Motor
(Figure 8.5.3.56a).
Replacement
1 Reinstall the End Wall Motor onto the Motor Bracket.
2 Reconnect the End Wall Motor Wire Harness.
3 Reinstall the End Wall Motor Bracket onto the Finisher frame, making sure the End Wall Link is
captured inside the End Wall Motor yoke.
4 Use two screws to secure the End Wall Motor Bracket to the Finisher frame.
5 Reinstall the End Wall Spring, with one end of the Spring attached to the End Wall Motor Bracket
and the other end attached to the end of the End Wall Link.
6 Route the End Wall Motor wire harness through the harness clips.
7 Reinstall the Harness Holder and use two screws to secure the Holder to the Finisher frame.
8 Reinstall the Unload While Run Switch.
9 Reinstall the Stapler Door Inner Cover Assembly.
Options
3/99
8-400 DocuPrint N24, N32 and N40 Service Manual