Xerox DocuPrint N24 Service Manual page 644

Replacement
1 Position the Roll with the latch end facing out, and slide the Roll onto the shaft.
2 Rotate and push the Roll down the shaft until the latch locks the Roll into place.
3 Repeat steps 1 and 2 for the remaining two Rolls.
4 Reinstall the Chute by sliding the opening in the rear of the Chute into the tab on the frame, then
slightly squeezing the Chute and hooking the tab at the front of the Chute into the opening on the
frame.
5 Reinstall the paper tray.
6 Verify proper operation and check registration using ADJ 4.1.
NOTE: Repeat steps 1 through 6 for each tray if its respective rolls are changed.
Options
3/99
8-206 DocuPrint N24, N32 and N40 Service Manual