Xerox DocuPrint N24 Service Manual page 944

8.5.6.3.2 Paper Path for Paper to be Stapled and Stacked
Paper leaves the Fuser Exit area and enters the Docking Cover. If the paper exiting the printer is des-
tined for the Finisher, the IN Gate drops down and diverts the paper into the Transport. If the paper exit-
ing the printer is not destined for the Finisher, the IN Gate remains up and the paper continues on into
the Face Down Bin.
The Transport carries the paper to the Transport Chute where Transport Rolls move the paper into the
Exit Chute. The Exit Chute uses Rolls and rubber paddles to move the paper into the Eject area. If the
paper is to be collected into sets and stapled, the Eject Rolls rotate in reverse and drive the paper back
into the Compiler Bin. When the correct number of sheets has entered the Bin, the Tamper aligns the
edges of the paper sheets to form a neat paper set. The Stapler then drives a staple through the set.
The Eject Rolls drive the paper set out of the Stapler and into the Offset Rolls. The Offset Rolls shift
each paper set slightly from the previous set as they are delivered into the Stacker Bin.
3/99
Options 8-506 DocuPrint N24, N32 and N40 Service Manual