8 Position the Harness Support against the Main Drive Assembly (ensure the bearing is in place).
9 Rotate the Registration Clutch and in the Feed Clutch so the slots in the Clutches line up with the
key on the Harness Support, then press the Support against the Main Drive Assembly.
10 Use the three screws to secure the Harness Support to the Main Drive Assembly.
11 Reconnect Registration Clutch inline connector (P/J 200).
12 Reconnect P/Js 104, 602, 209, 600, and 601.
13 Insert the wiring harnesses into the upper right cable clamp and close the clamp.
14 Reinstall the Left Cover Interlock Switch.
15 Reinstall the Inner Cover - LH, and use one screw to secure the Cover to the printer frame.
16 Reinstall the Rear Cover.
17 Reinstall the EP Cartridge.
18 Reinstall the Fuser Full Cover
19 Close the Left Upper Cover Assembly.
DocuPrint N24, N32, N40, N3225, and N4025
2/2000
4-81
Repair Procedures