Rep 8.5.3.83 Finisher Pwb Assembly - Xerox DocuPrint N24 Service Manual

REP 8.5.3.83 Finisher PWB Assembly

Parts List on PL 8.5.2.20
Removal
1 Switch off the printer power and disconnect the AC Power Cord.
2 Roll the Finisher away from the printer until it stops.
3 Disconnect the Finisher AC Power Cable and Interface Cable from the printer.
4 Remove the Harness Cover (REP 8.5.3.8).
5 Remove the Finisher PWB Cover (REP 8.5.3.10).
6 Loosen, but do not remove, the screw that is located at the top center of the PWB Top Cover
(Figure 8.5.3.83a).
7 Remove the eleven screws securing the PWB Top Cover to the PWB Bracket (Figure 8.5.3.83a).
8 Lift the PWB Top Cover up and away from the Bracket.
9 Disconnect the twelve P/Js that are connected to the Finisher PWB (Figure 8.5.3.83a).
10 Remove the eight screws securing the Finisher PWB to the PWB Bracket, and remove the
Finisher PWB from the Bracket (Figure 8.5.3.83a).
Replacement
1 Position the Finisher PWB onto the PWB Bracket. Use eight screws to secure the Finisher PWB
to the PWB Bracket.
2 Reconnect the twelve P/Js to the Finisher PWB.
3 Reinstall the PWB Top Cover by first slipping the keyed hole at the top of the Cover, over the
loosened screw on the PWB Bracket. Use eleven screws to secure the PWB Top Cover to the
PWB Bracket.
4 Tighten the loose screw that is located at the top center of the PWB Top Cover.
5 Reinstall the Finisher PWB Cover.
6 Reinstall the Harness Cover.
7 Reconnect the Finisher to the printer.
Options
3/99
8-446 DocuPrint N24, N32 and N40 Service Manual