Xerox DocuPrint N24 Service Manual page 964

8.5.6.5.4 Tamper Motor
The Finisher PWB switches on the Tamper Motor when a paper set in the Compiler Bin is ready to be
sent to the Stapler. The Tamper is attached to the Tamper Drive Belt. When the Tamper Motor is
switched on, it pulses, which in turn taps the Tamper against the side of the paper set. The Tamper
Home Sensor monitors the position of the Tamper.
Tamper Mechanical Drive Components
1 Tamper Motor
A +24 VDC stepper motor. Drives the Tamper Drive Belt.
2 Tamper Drive Belt
Drives the Tamper.
3 Tamper
Attached to the Drive Belt. The side of the Tamper taps the edge of the paper set to align
the set before stapling.
4 Tamper Home Sensor
Monitors the position of the Tamper when it is not actuated.
Options
3/99
8-526 DocuPrint N24, N32 and N40 Service Manual