Xerox DocuPrint N24 Service Manual page 168

Replacement
1 Position the MBF Feed Clutch with the gear facing out, and slide the Clutch onto the Feed Shaft.
2 Rotate the Clutch so the notch in the Clutch fits into the key in the Assembly (Figure 4.3.7d).
3 Use and E-ring to secure the MBF Feed Clutch to the Feed Shaft.
4 Reinstall the Link Spring onto the Rear Latch.
5 Slide the MBF Link Gear, along with the MBF Drive Gear Assembly, onto the idler shaft.
6 Hook the free end of the Link Spring around the bottom of the MBF Drive Gear Assembly.
7 Reconnect the P/J running to the MBF Feed Clutch.
8 Reinstall the MBF Rear Hook Bracket.
9 Tighten the screw located under the clutch notch.
10 Reinstall the MBF Top Cover.
11 Reinstall the MBF Assembly.
12 Reinstall the Duplex Module.
13 Verify proper operation.
Repair Procedures
2/2000
4-54 DocuPrint N24, N32, N40, N3225 and N4025