Xerox DocuPrint N24 Service Manual page 974

10 Inspect the Transport Rolls and Pinch Rolls. The Transport Rolls and Pinch Rolls are clean, not
broken, and free of obvious wear.
Y N
|
Replace the Transport Rolls (REP 8.5.3.93).
11 Replace the Transport Cover Assembly (REP 8.5.3.91).
12 Pull the Transport Assembly a few inches away from the Docking Assembly and inspect the
position of the jammed paper. The leading edge of the paper exited the Fuser Exit area.
Y N
|
Go to section 7 and troubleshoot for a possible Fuser Exit jamming problem.
13 Reattach the Transport Assembly to the Docking Assembly. Enter Diagnostic Mode - Output -
Gate Solenoid Operation - Gate In Pull to check IN Gate Solenoid open. Enter Diagnostic Mode -
Output - Gate Solenoid Operation - Gate In Push to check IN Gate Solenoid close. The IN Gate
Solenoid opens and closes when you run tests - Gate In Pull and Gate In Push.
Y N
|
Replace the IN Gate Solenoid (REP 8.5.3.90).
14 While running step 13, inspect the IN Gate. The IN Gate Actuator raises and lowers the IN Gate
as you toggle between Gate In Pull and Gate In Push.
Y N
|
Replace the IN Gate Lever and Spring (REP 8.5.3.86).
15 Replace the IN Gate Support Assembly (REP 8.5.3.85). The error message reappears.
Y N
|
Problem solved.
16 Go to section 7 and troubleshoot the printer Fuser and Offset Units for stalling, slipping, and
broken parts .
Options
3/99
8-536 DocuPrint N24, N32 and N40 Service Manual