Xerox DocuPrint N24 Service Manual page 861

Replacement
1 Slip the Paddle Drive Belt over the Paddle Gear.
2 Press the Paddle onto the Paddle Cover Assembly.
3 Reinstall the Sensor Bracket Assembly onto the Paddle Cover Assembly, and use one screw to
secure the Bracket.
4 Reinstall the Drive Gear onto the other end of the Belt, and position the Gear in the Paddle Cover
Assembly.
5 Slide the Paddle Cover Assembly onto the Eject Pinch Roll Shaft. Use an E ring to secure the
Paddle Cover Assembly to the Eject Pinch Roll Shaft.
6 Slide the Front Pinch Roll Cover onto the Eject Pinch Roll Shaft, and use two screws to secure
the Cover to the Shaft.
7 Reinstall the Eject Pinch Roll Assembly.
8 Reinstall the Eject Chute Assembly.
9 Raise and lower the Eject Chute Assembly to make sure it moves freely, and the Stack Height
Actuator and Pinch Rolls also move freely.
10 Reinstall the Eject Cover.
11 Reinstall the Upper Rear Cover.
12 Reinstall the Stapler Door Inner Cover Assembly.
DocuPrint N24, N32 and N40 Service Manual
3/99
8-423 Options