Xerox DocuPrint N24 Service Manual page 474

Replacement
1 Reinstall the Duplex Exit Gate Solenoid onto the Bracket.
2 Line up the two screw holes in the Bracket with the two screw holes in the Solenoid, and use two
short screws to secure the Solenoid to the Bracket.
3 Make sure the Exit Gate Link is in place.
4 Rotate the Solenoid plunger so the fork in the Link will slip through the slot in the plunger.
5 Press the Solenoid Bracket against the Duplex frame.
6 Use two screws to secure the Bracket to the frame.
7 Lift and release the Solenoid plunger to make sure it opens the Link correctly.
8 Reconnect P/J222 to the Duplex PWB.
9 Reroute the wire harnesses through the two wire clips in the Solenoid Bracket.
10 Reinstall the Duplex Rear Cover.
11 Reinstall the Duplex Cover.
Options
3/99
8-36 DocuPrint N24, N32 and N40 Service Manual