Replacement
1 Reinstall the Set Clamp Motor onto the Motor Bracket, and use two screws to secure the Motor.
2 Slide the Shaft Pulley, with the lip facing away from the Motor, onto the Motor Shaft. Use the E-
ring to secure the Pulley to the Shaft.
3 Reinstall the Motor Bracket onto the Finisher frame, by first slipping the Set Clamp Drive Belt
over the Shaft Pulley. Use two screws to secure the Motor Bracket to the Finisher frame.
4 Reconnect P864 and J842.
5 If removed, reinstall the Finisher PWB Cover and the Harness Cover.
6 Reinstall the Eject Bracket Assembly.
7 Reinstall the Offset Home Sensor.
8 Reinstall the Eject Clamp Sensor.
9 Reinstall the Upper Rear Cover.
10 Reconnect the Finisher to the printer.
DocuPrint N24, N32 and N40 Service Manual
3/99
8-409
Options