Repair Analysis Procedures; Rap 8.3.7.1 Error Code "Clear Area A / Reset Env/Pass - Xerox DocuPrint N24 Service Manual

8.3.7 Repair Analysis Procedures

RAP 8.3.7.1 Error Code "Clear Area A / Reset ENV/PASS"

1 Error message "Clear Sheets Reset ENV/PASS" was displayed
Y N
|
Go to step 6.
2 Inspect the Envelope Feed Sensor for paper scraps that may be actuating the sensor. The
Sensor is free of paper scraps.
Y N
|
Remove the paper scraps.
3 Enter Diagnostic Mode - Input H/L, ENV Feedout Sensor Detect. Insert a sheet of paper into the
Envelope Feed Sensor and press [4], then remove the sheet of paper and press [4]. The Control
Panel LCD displays "IS WITH PAPER" when you insert the paper into the Feed Sensor and "IS
WITHOUT PAPER" when the paper is removed.
Y N
|
Check the wiring between P/J 132 and P/J 702 (WIR 8.3.5.1). If OK, replace the Envelope
Feed Sensor (PL 8.3.2.3).
4 Replace the Envelope Feeder PWB (REP 8.3.3.7). The error message reappears.
Y N
|
Problem solved.
5 Check the wiring between P/J 700 and P/J 403 (WIR 8.3.5.1). If OK, replace the Printer Engine
Controller PWB (REP 4.10.6).
6 Inspect the paper path for paper scraps that may cause a paper jam. The paper path is free of
paper scraps.
Y N
|
Clean the paper path.
7 Inspect the envelopes that are loaded in the Envelope Tray. The envelopes that are loaded in the
Envelope Tray are smooth (not wrinkled) and undamaged.
Y N
|
Replace the envelopes with new envelopes.
8 Enter Diagnostic Mode - Input H/L, ENV Feedout Sensor Detect. Insert a sheet of paper into the
Envelope Feed Sensor and press [4], then remove the paper and press [4]. The Control Panel
LCD displays "IS WITH PAPER" when you insert the paper into the Feed Sensor and "IS
WITHOUT PAPER" when the paper is removed.
Y N
|
Check the wiring between P/J 132 and P/J 702 (WIR 8.3.5.1). If OK, replace the Envelope
Feed Sensor (PL 8.3.2.3).
9 Enter Diagnostic Mode - Output Test, ENV Feed Motor Operation to start the Envelope Feeder
Motor. The Envelope Feeder Motor runs when the Output Test starts.
Y N
|
Go to step 12.
DocuPrint N24, N32 and N40 Service Manual
3/99
8-157 Options