Xerox DocuPrint N24 Service Manual page 204

Replacement
1 Position the Switch against the opening in the Bracket so the two wire terminals are on the
outside of the Bracket, away from the screw hole.
2 Press the Switch into the Bracket.
3 Position the Switch Lever against the Switch, with the foot of the Lever facing out.
4 Rotate the Switch Lever so it is straight up, and slide it onto the Bracket.
5 Press and release the Lever to make sure it is functioning correctly.
6 Open the Duplex Unit and the Left Upper Cover.
7 Position the Switch Bracket against the printer frame, slightly below the screw hole in the printer
frame.
8 Raise the Bracket so the aligning key at the bottom of the Switch Assembly matches with the slot
in the printer frame.
9 Use one screw to secure the Interlock Switch Assembly to the printer frame.
10 Open and close the Left Upper Cover to make sure the Switch functions correctly.
11 Reconnect the two wires to the Interlock Switch.
12 Reinstall the Rear Cover Assembly.
13 Verify proper operation.
Repair Procedures
2/2000
4-90 DocuPrint N24, N32, N40, N3225 and N4025