Replacement
1 Insert the Stacker Bin ID Sensor into the Sensor cutouts in the Sensor Bracket.
2 Reconnect J837 to the Sensor.
3 Reinstall the Sensor Bracket onto the frame, making sure you align the positioning hole in the
Bracket with the positioning tab on the frame.
4 Use one screw to secure the Bracket and Sensor to the frame.
5 Route the ID Sensor wire harness through the harness clip.
6 Reinstall the Upper Rear Cover.
7 Reconnect the Finisher to the printer.
DocuPrint N24, N32 and N40 Service Manual
3/99
8-335
Options