Rep 8.5.3.68 Stack Height Sensor - Xerox DocuPrint N24 Service Manual

REP 8.5.3.68 Stack Height Sensor

Parts List on PL 8.5.2.13
Removal
1 Switch off the printer power and disconnect the AC Power Cord.
2 Remove the Stapler Door Inner Cover Assembly (REP 8.5.3.3).
3 Remove the Upper Rear Cover (REP 8.5.3.5).
4 Remove the Eject Cover (REP 8.5.3.7).
5 Remove the Eject Chute Assembly (REP 8.5.3.62).
6 Remove the Eject Pinch Roll Shaft Assembly (REP 8.5.3.63).
7 Release the latches that are securing the Stack Height Sensor to the Sensor Bracket, and
remove the Sensor (Figure 8.5.3.68a).
Replacement
1 Position the Stack Height Sensor into the Sensor cutout in the Sensor Bracket.
2 Raise and lower the Stack Height Sensor Actuator to make sure the Actuator arm moves freely
between the arms of the Stack Height Sensor.
3 Reinstall the Eject Pinch Roll Shaft Assembly.
4 Reinstall the Eject Chute Assembly.
5 Raise and lower the Eject Chute Assembly to make sure it moves freely, and the Stack Height
Actuator and Pinch Rolls also move freely.
6 Reinstall the Eject Cover.
7 Reinstall the Upper Rear Cover.
8 Reinstall the Stapler Door Inner Cover Assembly.
Options
Figure 8.5.3.68a. Stack Height Sensor.
3/99
8-424 DocuPrint N24, N32 and N40 Service Manual