Xerox DocuPrint N24 Service Manual page 849

6 Slide the Pulley and the Set Clamp Actuator over the rear end of Shaft 1, and use an E-ring to
secure them to the Shaft.
7 Slide the front plastic bearing onto the front end of Shaft 2, and use one screw to secure the
bearing to the Finisher frame.
8 Slide the rear plastic bearing onto the rear end of Shaft 2, and use one screw to secure the
bearing to the Finisher frame.
9 Slide the Eject Gear onto the rear end of Shaft 2, and use an E-ring to secure the Gear to the
Shaft.
10 Slide the Offset Lever over the rear end of Shaft 2, and use an E-ring to secure the Offset Lever.
11 Reinstall the Set Clamp Motor.
12 Reinstall the Eject Bracket Assembly.
13 Reinstall the Offset Home Sensor.
14 Reinstall the Eject Clamp Sensor.
15 Reinstall the Eject Roll Chute, and use four screws to secure the Chute.
16 Reinstall the Top Bin Assembly.
17 Reinstall the Harness Cover.
18 Reinstall the Eject Cover.
19 Reinstall the Upper Rear Cover.
20 Reconnect the Finisher to the printer.
DocuPrint N24, N32 and N40 Service Manual
Figure 8.5.3.61a. Eject Shaft.
3/99
8-411 Options