Xerox DocuPrint N24 Service Manual page 245

Main Menu Selection
OFFSET MOTOR
ROTATIONS
EXIT GATE SOLENOID
INVERT CLUTCH CONTROL
MBX MOTOR ON/OFF
MBX SOLENOID GATES
FINISHER
OPERATIONS
DocuPrint N24, N32 and N40 Service Manual
Table 5.4.5a. Output Test Table
Sub Menu Selection
NORMAL ROTATION
REVERSE ROTATION
Invert clutch
Invert CCW
Invert clutch
Invert CW
GATE IN PULL
2 BIN GATE
3 BIN GATE
4 BIN GATE
5 BIN GATE
6 BIN GATE
7 BIN GATE
8 BIN GATE
9 BIN GATE
10 BIN GATE
GATE IN SO PULL
GATE IN SO PUSH
FINISHER TRANSP.
MOTOR
TAMPER FRONT
TAMPER REAR
COMPILER U/D SO.
END WALL FORWARD
END WALL REVERSE
STAPLER FRONT
3/99
5-17
Comment
NOTE: Each test will run for 2 minutes if en-
tered into directly from power on diagnos-
tics. If a second test is selected after the 2
minute timer runs out without powering off
and on, the second test will not stop until
power off is pressed.
witches gate to face-up bin
S
Power off to deenergize
Toggle between CCW and CW to energize
clutch
Power off to deenergize
Energizes Mailbox Motor
Energizes Mailbox Gates
Gate is opened, MBX bin is ready for output
Gate 2 solenoid energizes
Gate 3 solenoid energizes
Gate 4 solenoid energizes
Gate 5 solenoid energizes
Gate 6 solenoid energizes
Gate 7 solenoid energizes
Gate 8 solenoid energizes
Gate 9 solenoid energizes
Gate 10 solenoid energizes
Toggle between push and pull to
Open and close gate
Power off to stop motor
Toggle between front and rear to observe
tamper operation
Power off to deenergize
Toggle between forward and reverse to
observe end wall operation
Toggle between front and rear to observe
stapler movement.
General Procedures and Information