Running A Service Sensor (H/L) Input Test - Xerox DocuPrint N24 Service Manual

5.4.6 Running a Service Sensor (H/L) Input Test

1 Enter Diagnostic Mode (5.4.3).
2 The printer is in Diagnostic Mode.
3 Press[1] to display "Service Sensor (H/L) Input Test".
4 Press [4] to display the 1st test from the Main Menu selection in the table (Table 5.4.6a).
5 Press [1] to scroll up or [5] to scroll down through the menu selection to find the desired Output
Test.
6 Press [4] when the desired Input Test is displayed.
The test will automatically stop after 5 seconds.
7 If the desired test has a sub test then press [5] to scroll through the sub test items.
Press [4] again when the desired sub test is displayed. The test will automatically stop after 5
seconds.
8 Press [2] to return to the Input Test.
9 Repeat steps 5 - 7 until all desired Input Tests are complete.
10 When you have finished running the Service Sensor (H/L)Input test, Press [2] to exit to the top of
the Diagnostic Mode or switch off the printer power to exit Diagnostic Mode.
Main Menu Selection
L/H
INTERLOCK
CABINET TRAY
INTERLOCK
DOOR B
INTERLOCK
ROS MOTOR
READY
NO PAPER SENSOR
DETECT
LEVEL SENSOR
DETECT
DocuPrint N24, N32 and N40 Service Manual
Table 5.4.6a. Service Sensor (H/L) Input Test Table
Menu Selection
SELECT TRAY 1
SELECT TRAY 2
SELECT TRAY 3
SELECT TRAY 4
SELECT TRAY 5
SELECT MBF/ENV
3/99
5-19 General Procedures and Information
Comment
H = Cover is OPEN
L = Cover is CLOSED
(HCF Door C)
H = Cover is OPEN
L = Cover is CLOSED
H = Cover is OPEN
L = Cover is CLOSED
H = Is READY
L = Not READY
H = Is WITHOUT paper
L = Is WITH paper
H =Is WITHOUT paper
L = Is WITH paper
H =Is WITHOUT paper
L = Is WITH paper
H = Is WITHOUT paper
L = Is WITH paper
H = Is WITHOUT paper
L = Is WITH paper
H = Is WITHOUT paper
L = Is WITH paper