Registration (Inboard to Outboard)
Measure the registration on two consecutive System Controller Test Prints. Fold the outboard
edge to the inboard edge and crease the paper. Observe the fold at the zero reference line,
(Figure 7.33g).
1 The fold is within +/- 2.0 mm from the zero reference line.
Y
N
|
Go to ADJ 4.4.
2 The printed test patterns meet the Inboard to Outboard registration specification. Go to the Skew
checkout on the next page.
Figure 7.33g. System Controller Test Print (inboard to outboard)
Zero Reference
Line
DocuPrint N24, N32, N40, N3225, and N4025
2/2000
7-51
Repair Analysis Procedures (RAP)
SR1503R