Xerox DocuPrint N24 Service Manual page 583

Replacement
1 Position the Feed Belt so the tooth of the Belt is pointing in the direction as shown in the
illustration (Figure 8.3.3.8c).
2 Slide the Feed Belt over the Bottom Shaft.
3 Reinstall the Bottom Shaft into the slot in the Feeder, and slide the Bearings out to the ends of
the Shaft.
4 Use two K clips to secure both ends of the Bottom Shaft to the Feeder.
5 Slide the Feed Shaft through the free end of the Belt, and reinstall the Feed Shaft into the slot in
the Feeder.
6 Slide the Bearings out to the ends of the Shaft.
7 Use two K clips to secure both ends of the Feed Shaft to the Feeder.
8 Reinstall the Motor Assembly.
9 Reinstall the Center Bracket Assembly.
10 Reinstall the Rear Cover.
11 Reinstall the Top Cover.
12 Reinstall the Bottom Cover.
DocuPrint N24, N32 and N40 Service Manual
Figure 8.3.3.8b. Feed Belt Removal.
Figure 8.3.3.8c. Feed Belt.
3/99
8-145 Options