Rep 8.5.3.52 End Wall Open Sensor - Xerox DocuPrint N24 Service Manual

REP 8.5.3.52 End Wall Open Sensor

Parts List on PL 8.5.2.11
Removal
1 Switch off the printer power and disconnect the AC Power Cord.
2 Disconnect the Finisher from the Printer (REP 8.5.3.1).
3 Remove the Stapler Door Inner Cover Assembly (REP 8.5.3.3)
4 Remove the Upper Rear Cover (REP 8.5.3.5).
5 Remove the Transport Assembly (REP 8.5.3.11).
6 Remove the Upper Left Cover (REP 8.5.3.12).
7 Remove the four screws securing the Tie Plate to the Finisher frame (Figure 8.5.3.52a). Remove
the Tie Plate.
8 Press in and release the Sensor latches that are securing the Sensor to the Bracket (Figure
8.5.3.52b). Remove the Sensor.
9 Disconnect P840 from the Sensor (Figure 8.5.3.52b).
Options
Figure 8.5.3.52a. Tie Plate.
3/99
8-394 DocuPrint N24, N32 and N40 Service Manual