Xerox DocuPrint N24 Service Manual page 634

Replacement
1 Position the Feed Motor so the wire harness is on the left side of the Motor.
2 Slip the Drive Belt over the Feed Motor Gear.
3 Press the Motor against the HCF frame and align the Motor Bracket with the frame positioning
tabs.
4 Use two screws to secure the Motor Bracket to the frame, but do not tighten fully.
5 Remove the slack from the Drive Belt by pushing the Motor Bracket in the direction of the arrow
(Figure 8.4.3.3b) and tightening the two screws securing the Bracket to the frame.
6 Reconnect P/J217 to the HCF PWB.
7 Reinstall the Rear Cover.
Options
Figure 8.4.3.3b. HFC Motor and Belt
3/99
8-196 DocuPrint N24, N32 and N40 Service Manual