Xerox DocuPrint N24 Service Manual page 146

13 From the rear of the printer, remove the screw that secures the Take Away Roll Clutch stop
bracket (Figure 4.2.7b).
14 Remove the E-ring that secures the gear to the end of the Take Away Roll Shaft (Figure 4.2.7b).
15 Remove the gear and the E-ring located next on the Take Away Roll Shaft (Figure 4.2.7b).
16 Remove the screw that secures the Gear Stopper. Remove the Gear Stopper (Figure 4.2.7b).
17 Remove the E-ring and bearing from the front of the Take Away Roll Shaft (Figure 4.2.7b).
18 Slide the Take Away Roll Shaft and the Retard assembly toward the rear of the printer until the
front of the shaft is free of the printer frame.
19 Carefully remove the assembly out the front of the printer.
20 Note the position and direction of all the bearings on the Take Away Roll Shaft.
21 Remove the E-ring that secures the Retard Assembly to the Take Away Roll Shaft. Remove the
Retard Assembly (Figure 4.2.7b).
Repair Procedures
Figure 4.2.7b. Take Away Roll.
2/2000
4-32 DocuPrint N24, N32, N40, N3225 and N4025