Rep 4.1.6 Left Upper Cover Assembly - Xerox DocuPrint N24 Service Manual

REP 4.1.6 Left Upper Cover Assembly

Parts List on PL 6.2
Removal
1 Switch off the printer power and disconnect the AC Power Cord.
2 Remove the Rear Cover (REP 4.1.3).
3 Remove the Duplex Unit, if installed.
4 Open the Left Upper Cover.
CAUTION When the Left Upper Cover is open, the BTR is exposed. Do not touch the BTR.
Grease and dirt on, or physical damage to the BTR will effect print quality.
5 Open Tray 1 and carefully open the latch securing the Front Shaft Pin Hinge, and slide the Pin
Hinge out of the Cover Assembly. Do not slide the Pin Hinge completely out of the printer frame
(Figure 4.1.6a).
6 Repeat step 5 with the Rear Shaft Pin Hinge, and slide the Pin Hinge out of the Cover Assembly.
Do not slide the Pin Hinge completely out of the printer frame (Figure 4.1.6a).
7 Remove the two screws securing the two Cover Support Straps to the frame, and remove the
Cover (Figure 4.1.6a).
Replacement
1 Reinstall the Left Upper Cover Assembly so the Pin Hinge openings in the Cover arms line up
with the Pin Hinge holes in the printer frame.
2 Slide the Rear Shaft Pin Hinge into the hinge opening in the Left Upper Cover arm, until the latch
locks the Pin Hinge onto the shaft.
3 Open Tray 1 and slide the Front Shaft Pin Hinge into the hinge opening in the Left Upper Cover
arm, until the latch locks the Pin Hinge onto the shaft.
4 Use two screws to secure the two Cover Support Straps to the frame.
5 Reinstall the Rear Cover.
6 Open and close the Cover to make sure it opens and latches correctly.
7 Verify proper operation.
Repair Procedures
3/99
4-12 DocuPrint N24, N32 and N40 Service Manual