Rep 8.5.3.94 Transport Entrance Sensor - Xerox DocuPrint N24 Service Manual

REP 8.5.3.94 Transport Entrance Sensor

Parts List on PL 8.5.2.24
Removal
1 Switch off the printer power and disconnect the AC Power Cord.
2 Open the Transport Cover.
3 Carefully lift up on the Transport Entrance Sensor Cover while you release the two latches
securing the Cover to the Transport, and remove the Cover (Figure 8.5.3.94a).
4 Remove the screw securing the Transport Entrance Sensor Plate to the Transport, and remove
the Plate along with the attached Sensor (Figure 8.5.3.94a).
5 Disconnect J275M from the Sensor (Figure 8.5.3.94a).
6 Release the latches securing the Sensor to the Plate, and remove the Sensor (Figure 8.5.3.94a).
Replacement
1 Position the Transport Entrance Sensor and press the latches into the cutouts in the Plate.
2 Reconnect J275M to the Sensor.
3 Reinstall the Sensor Plate onto the Transport, by slightly closing the Top Cover and sliding the
Sensor, with the actuator pointing up, into position.
4 Make sure you do not break the Sensor actuator while you are reinstalling the Sensor. Use one
screw to secure the Plate to the Transport.
5 Reinstall the Transport Entrance Sensor Cover by first inserting the two latches into the latch
openings in the Transport, then pressing the Cover into place.
6 Close the Transport Cover.
Options
Figure 8.5.3.94a. Transport Entrance Sensor.
3/99
8-462 DocuPrint N24, N32 and N40 Service Manual