Rep 8.5.3.11 Transport Assembly - Xerox DocuPrint N24 Service Manual

REP 8.5.3.11 Transport Assembly

Parts List on PL 8.5.2.23 / PL 8.5.2.24
Removal
1 Switch off the printer power and disconnect the AC Power Cord.
2 Disconnect the Finisher from the Printer (REP 8.5.3.1).
3 Remove the two screws securing the Transport Rear Cover to the Transport Assembly, and
remove the Cover (Figure 8.5.3.11a).
4 Disconnect J256M, J262A, J268A, and J279.
5 Fold up and lock the two Support Arms that are located under the Transport Assembly, and lower
the Assembly (Figure 8.5.3.11a).
6 Remove the K Clip from the Transport Assembly front pivot shaft (Figure 8.5.3.11a).
7 Slide the Transport Assembly toward the rear to free the front pivot (Figure 8.5.3.11a).
8 Pull the front of the Transport Assembly away from the frame and slide the Assembly toward the
front to free the rear pivot. Remove the Assembly (Figure 8.5.3.11a).
Replacement
1 Hold the Transport Assembly vertically, and insert the Transport Assembly rear pivot into the hole
in the rear Transport Bracket.
2 Insert the Transport Assembly front pivot into the hole in the front of the Assembly.
3 Use a K Clip to secure the front pivot shaft.
4 Raise the Transport Assembly into the horizontal position, and lower and lock the two Support
Arms that are located under the Assembly.
5 Reconnect J256M, J262A, J268A, and J279.
6 Reinstall the Transport Rear Cover onto the Transport Assembly, and use two screws to secure
the Cover.
7 Reconnect the Finisher to the Printer.
Options
3/99
8-326 DocuPrint N24, N32 and N40 Service Manual