Xerox DocuPrint N24 Service Manual page 246

Main Menu Selection
General Procedures and Information
Table 5.4.5a. Output Test Table
Sub Menu Selection
STAPLER REAR
STAPLE MOTOR
EJECT CL/OFF CW
EJECT CL/OFF CCW
EJECT FWD, LOW
EJECT FWD, HIGH
EJECT REVERSE
SET CLAMP
FINISHER ELVR CW
FINISHER ELVR CCW
FINISHER BIN 1 CW
FINISHER BIN 1 CCW
FINISHER BIN 2 CW
FINISHER BIN 2 CCW
FINISHER BIN 3 CW
FINISHER BIN 3 CCW
FINISHER UNLOAD WHILE
RUN
2/2000
5-18
Comment
NOTE: If stapler is in home position press
enter twice to move it to the rear position.
If stapler is in the rear position, press enter
once to move it to front position or press
enter twice to move it to home position.
Eject motor comes on
Power off to stop motor
Toggle enter button to cycle clutch. Ensure
the stack height sensor is in the down posi-
tion before powering off to exit diagnostics.
Motor cycles for 2 seconds
Motor cycles for 2 seconds
Motor cycles for 2 seconds
Toggle enter button to observe rotation
Elevator goes up
NOTE: Elevator will not move if the stack
height sensor assembly is not in the down
position.
Elevator goes down
Finisher Bin one goes down
Finisher Bin one goes up
Finisher Bin two goes down
Finisher Bin two goes up
Finisher Bin three goes down
Finisher Bin three goes up
Observe the LED on top of the finisher
unload button to verify it comes on.
Power off to turn off light.
DocuPrint N24, N32, N40, N3225, and N4025