CHAPTER 14
Performing Initial Configuration
EX9200 Switch Default Configuration
Copyright © 2017, Juniper Networks, Inc.
EX9200 Switch Default Configuration on page 171
Connecting and Configuring an EX9200 Switch (CLI Procedure) on page 172
Each EX9200 switch is programmed with a factory default configuration that contains
the values set for each configuration parameter when a switch is shipped. The default
configuration file sets values for system parameters such as the Address Resolution
Protocol (ARP) aging timer, the system log, and file messages, while also enabling the
Link Layer Discovery Protocol (LLDP) protocol, the Rapid Spanning Tree Protocol (RSTP),
Internet Group Management Protocol (IGMP) snooping, and storm control.
When you commit changes to the configuration, a new configuration file is created that
becomes the active configuration. You can always revert to the factory default
configuration. See Reverting to the Default Factory Configuration for the EX Series Switch.
This topic shows the factory default configuration file of an EX9200 switch:
system {
arp {
aging-timer 5;
}
syslog {
user * {
any emergency;
}
file messages {
any notice;
authorization info;
}
file interactive-commands {
interactive-commands any;
}
}
}
protocols {
lldp {
interface all;
}
}
171