Figure 18: Ln2600 Router With Top Cover Panel Open; Figure 19: Ln2600 Router With Interface Cables - Juniper LN2600 Hardware Manual

Copyright © 2015, Juniper Networks, Inc.

Figure 18: LN2600 Router with Top Cover Panel Open

1— Top cover panel
2— Protective rubber gasket
Pass the interface cables that are coming out of the interface cable entrance through
8.
the grooves present in the cable seal unit.
The cable seal is a small circular-shaped foam structure with grooves for the cables
to pass through. The cable seal sits tightly on the interface cable entrance and prevents
water and dust particles from entering the cable management system.
NOTE: Ensure that each groove on the foam cable seal unit accommodates
only one cable through it.

Figure 19: LN2600 Router with Interface Cables

1— Interface cable entrance
2—Cable seal
Squeeze and slide the cable seal along with the interface cables into the interface
9.
cable entrance until one fourth of the cable seal foam is left.
Wrap the interface cables that are coming out from the other end of the cable seal
10.
with the hose bag, and secure it tightly with the Velcro that is attached to the hose
bag.
Chapter 3: Installing the LN2600 Rugged Security Router
3— Status LED
4— Bottom cable management unit
1 2
3— Interface cables
N T Y
W A R R A
D
R EM O VE
VO ID IF
N T Y
W A R R A
D
R EM O VE
VO ID IF
3
33