Restarting The System; Displaying The System Logs - Patton electronics SmartWare R.3.20 Software Configuration Manual

SmartWare Software Configuration Guide
Example: Defining the desired CLI version
The following example shows how to determine the running CLI version and define CLI version 2.10 for your
device, if you start from the configuration mode.
node(cfg)#show version cli
CLI version : 3.00
node(cfg)#cli version 2.10

Restarting the system

In case the SmartNode has to be restarted, the
a two-dialog, where the user is allowed to store any unsaved configuration data and finally confirms the
system restart.
IMPORTANT
The execution command
• graceful—reloads the system only if no voice calls are ongoing. If there are voice calls, the system waits until
they all are closed to reload.
forced—reloads the system without prompting for confirmation or for saving the running-configuration
•
(no need to type yes or no). The question whether to save the running-configuration is automatically
answered with no, the question whether to reload or not with yes.
Mode: Administrator execution
Step Command
1 node #reload
Example: Restarting the system
The following example shows how to restart the currently running system, if you start from the administrator
execution mode.
node#reload
System configuration has been changed.
Press 'yes' to store, 'no' to drop changes : yes
Press 'yes' to restart, 'no' to cancel : yes
The system is going down

Displaying the system logs

The system logs contain warnings and information from the system components of SmartWare. In case of
problems it is often useful to check the event or the supervisor logs for information about malfunctioning sys-
tem components. The event log stores general events such as flash full, DSP failed etc., comparable with the
event log on Windows NT. The supervisor log stores information from the system supervisor such as memory
full, task failed etc.
Basic system management configuration task list
reload
Restarting the system interrupts running data transfers and all
voice calls.
has been enhanced with the following options:
reload
Restarts the system
7 • Basic system management
command must be used. The reload command includes
Purpose
90