Table of Contents
Advertisement
SmartWare Software Configuration Guide
following table. The detail parameter is a number in the range 0 to 5 and indicates how much detail should be
logged.
Command to enable the monitor
node(cfg)# debug gateway sip error [detail]
node(cfg)# debug gateway sip transport
[detail]
node(cfg)# debug gateway sip registration
[detail]
node(cfg)# debug gateway sip datapath
[detail]
node(cfg)# debug gateway sip signaling
[detail]
Configuring multiple SIP services on a SIP gateway
SIP gateways can be configured for use with multiple SIP services at the same time. Therefore there is a sub-
mode service <name> within the gateway SIP. It is necessary to specify in the SIP interface, which service of the
gateway shall be used for this interface using the
SIP have been moved to the service submode:
•
authentication
•
call-transfer-version
•
contact-address
•
default-server
•
domain
•
nat-traversal
•
new-session-after-redirect
•
registrar
•
registration-lifetime
•
session-timer
•
session-timer-version
•
use profile sip
There is now also a new command
service. If there is more than one service configured on a gateway the realm must be configured on each service.
Configuring multiple SIP services on a SIP gateway
Logs all errors detected within the SIP gateway
Logs all SIP messages sent or received over the IP net-
work.
Logs information about user registration activities
Logs information related to media channels
Logs call signaling related information
command. The following commands of the gateway
service
realm
within the
service
39 • SIP gateway configuration
Output of the monitor
submode to define the realm to be used for this
503
Advertisement
Table of Contents
Troubleshooting
