Configuring The Terminal Type For Registration With The Gatekeeper; Troubleshooting - Patton electronics SmartWare R.3.20 Software Configuration Manual

SmartWare Software Configuration Guide
Configuring the terminal type for registration with the gatekeeper
H.323 gatekeepers may differentiate between two terminal types (terminals and gateways) of the registrant. In
some applications it is necessary for the gateway to register as a terminal, while in other applications it is neces-
sary to register as a gateway.with the gatekeeper. The default terminal type is gateway. It can be changed using
the following procedure: Usually you do not need to change this setting.
Procedure: Configure the registration type of the registration with the gatekeeper
Mode: Gateway H.323
Step
1 node (gw-h323)[h323]#terminal-type { termi-
nal | gateway }
Example: Configuring RAS registration type
The following example shows how to configure the RAS registration type.
node(cfg)#gateway h323 h323
node(gw-h323)[h323]#terminal-type gateway

Troubleshooting

You can display basic status information of the H.323 gateway using the following command:
Mode: Configure
Step
1
node (gw-h323)[h323]# show gateway
h323 status [detail level ]
Example: Display H.323 gateway status information
The following example shows how to display H.323 gateway status information and a sample output of the
command.
node(cfg)#show gateway h323 status
H.323 Gateway:
State:
Stack Handle:
RAS Engine
State:
Allocated Endpoints:
Allocated RAS Engines:
Allocated Control Channels:
Allocated Outgoing Logical Slowstart Channels: 0
Allocated Outgoing Logical Faststart Channels:0
Allocated Incoming Logical Channels:0
Gateway configuration task list
Command
Command
38 • H.323 gateway configuration
Purpose
Set the registration type of the gatekeeper reg-
istration.
Purpose
Displays H.323 gateway status information.
The detail level parameter is a number in the
range 0 to 5 and indicates how much detail
should be displayed.
h323
UP
0xb6a70c
UNREGISTERED
0
1
0
489