SmartWare Software Configuration Guide
node(pf-ppp)[PPPoE]#port ethernet 0 0
node(prt-eth)[0/0]#pppoe
node(pppoe)[0/0]#session green
node(session)[green]#use profile ppp PPPoE
Displaying PPP configuration information
This section shows how to display and verify the PPP configuration information.
Mode: Configure
Step
1
node (cfg) #show running-config
node (cfg) #show subscriber ppp [ name ] Displays configuration information of the PPP sub-
2
3
node (pf-ppp)[name]#show profile ppp
{ name | default }
Example: Display PPP subscriber configuration information
node(session)[green]#show subscriber ppp joe_example
Subscribers:
------------
Name:
Direction:
Authentication:
Identification (inbound):
Identification (outbound): patton/patton
Timeout for disconnect:
Max. sessions:
IP address:
Callback:
Binding:
Binding:
PPP configuration task list
Command
joe_example
dial-out
pap
(none)
no absolute timeout, no idle timeout
no limit
(none)
(none)
interface ppp_interface router
interface ppp_interface router
Purpose
Gives the best overview of all PPP related configura-
tion information. The following parts are of interest:
profile ppp default
•
profile ppp name
•
interface name
•
subscriber ppp name
•
port ethernet slot port
•
session name
•
scriber name or of all PPP subscribers
Displays the PPP profile name or the default PPP
profile
24 • PPP configuration
274