Patton electronics SmartWare R.3.20 Software Configuration Manual page 428

SmartWare Software Configuration Guide
Class
Service or
bearer-capability-not-
Option Not
available
Available
(Cont.)
service-or-option-not-
available
bearer-capability-not-
Service or
implemented
Option Not
Implemented
channel-type-not-imple-
mented
facility-not-implemented Drop original call
only-restricted-digital-
available
service-or-option-not-
implemented
Invalid Message invalid-call-reference
channel-does-not-exist
call-identity-does-not-
exist
Call router configuration task list
Table 16. Hunt group drop causes (Continued)
Default Behavior
Cause of the Hunt
Group Service
Drop original call
Drop original call
Drop original call
Drop original call
Drop original call
Drop original call
Drop original call
Drop original call
Drop original call
33 • Call router configuration
Description
The network normally provides the
requested bearer capability, but it is
unavailable at the present time. This can
be due to a temporary network problem
or subscription problem.
The network or remote equipment cannot
provide the requested service option for
an unspecified reason. This can be a sub-
scription problem.
The network cannot provide the bearer
capability requested by the user.
The network or the destination equipment
does not support the requested channel
type.
The remote equipment does not support
the requested supplementary service.
The network cannot provide unrestricted
digital information bearer capability. This
cause indicates that a device has
requested an unrestricted bearer service
but the equipment sending this cause only
supports the restricted version of the
requested bearer capability.
The network or remote equipment cannot
provide the requested service option for
an unspecified reason. This can be a sub-
scription problem.
The remote equipment receives a call with
a call reference value that is not currently
in use.
The receiving equipment is requested to
use a channel that is not activated on the
interface for calls. This cause indicates that
the equipment sending this cause has
received a request to use a channel not
activated on the interface for a call.
This cause indicates that a call resume has
been attempted with a call identity, which
differs from that in use for any presently
suspended call.
428