Patton electronics SmartWare R.3.20 Software Configuration Manual page 504

SmartWare Software Configuration Guide
Otherwise, it is not possible for the gateway to provide the correct credentials to the server, when challenged.
The syntax of the new realm command is as follows:
Mode: gateway sip/service
Step
1
[ name ] (svc-sip)[<name>]# realm <realm-
name>
As a consequence, the realm needs no longer be defined in the authentication command. The new syntax of
the authentication command is as follows:
Mode: sip/service
Step
1 [ name ] (svc-sip)[<name>]# authentication
<username> password <password>
[default]
For simple configurations, it is now also possible to directly specify the password for authentication of users to
be registered directly with the user command, which defines the users to be registered. This password will then
not only be used for registration of the user, but also for authentication of calls, which are originated by that
user. The new syntax of the user command is as follows:
Mode: gateway sip/service
Step
1
[ name ] (svc-sip)[<name>]# user <name> [display-
name <display-name>] [phone-context <phone-
context>] [password <pasword>]
The following procedure guides through the steps required to configure a SIP gateway and SIP interfaces for
multiple services.
Mode: Configure
Step
1
[ name ] (cfg)# gateway sip [<name>]
2
[ name ] (gw-sip)[<gw-name>]# bind interface <ip-if-
name>
3 [ name ] (gw-sip)[<gw-name>]# service <service-
name>
Configuring multiple SIP services on a SIP gateway
Command
Command
Command
Command
39 • SIP gateway configuration
Purpose
Defines the realm valid for this service.
Purpose
Defines authentication parameters for a
SIP service.
Purpose
Defines a user to be registered as
well as optionally a display name,
phone-context and a password for
the user.
Purpose
Create a SIP gateway
Bind the gateway to an IP interface
Create a SIP service
504