Patton electronics SmartWare R.3.20 Software Configuration Manual page 248

SmartWare Software Configuration Guide
interface, e.g. the default gateway, DNS server IP addresses, etc. To enable the DHCP-client on an IP interface
perform the steps described below.
Mode: context IP
Step
node (ctx-ip)[router]#interface name
1
node (if-ip)[ name ]#ipaddress dhcp
2
node (if-ip)[ name ]#show dhcp-client
3
Note
If you are connected to the SmartNode by Telnet over the IP interface on
which you enable the DHCP-client, the connection is lost after entering the
command
uted from the DHCP-server to connect to the SmartNode again!
Example: Enable DHCP-client on an IP interface
node(cfg)#context ip
node(ctx-ip)[router]#interface eth0
node(if-ip)[eth0]#ipaddress dhcp
node(if-ip)[eth0]#show dhcp-client
------------------------------------------------------------
Context:
Name:
IpAddress:
Default gateway:
Domain Name:
DNS:
Next Server Ip:
DHCP Server:
Lease obtained:
Lease expires:
State:
DHCP-client configuration tasks
Command
. You need to know the new IP address distrib-
ipaddress dhcp
router
eth0
172.16.224.102 255.255.0.0
172.16.1.10
pacific
172.16.1.10
146.228.10.16
172.16.1.10
172.16.1.10
2001-01-01T01:03:51
2001-01-01T09:03:51
Bound
Purpose
Creates an IP interface with name name and enters
'configure' configuration mode
Enables the DHCP-client on this IP interface. (See
note)
Displays status information about the DHCP-client
For example, default gateway, lease expire time,
etc.
21 • DHCP configuration
248