Using An Alternate Source Ip Address For Specific Destinations; Configuring Call-Hold On Isdn Interfaces; Enabling Display Information Elements On Isdn Ports - Patton electronics SmartWare R.3.20 Software Configuration Manual

SmartWare Software Configuration Guide
Mode: Context ip /interface <if-name>
Step
1 node (if-ip)[if- name ]# [no] rtp-encryp-
tion
Using an alternate source IP address for specific destinations
Normally, locally originated IP packets use the IP address of the outbound IP interface as their source address.
However, when using VPN tunnels there are situations, where locally originated IP packets must be sent using
the source IP address of an alternate interface. You can specify using the following command that for one or
more destination network the IP address of an alternate IP interface should be used. This configuration com-
mand affects all locally originated IP packets except those, which originate from explicitly bound components
like SIP and H.323.
Mode: context ip
Step
1 node (ctx-ip)[ctx- name ]# [no] source-
address-map <destination-network>
<destination-mask> <ip-interface-
name>
Configuring Call-Hold on ISDN interfaces
Normally, the call-hold feature is disabled on ISDN point-to-point links and enabled on ISDN point-to-mul-
tipoint links. However, you can manually enable or disable the Call-Hold feature using the following com-
mand: The default setting can be achieved using the 'auto' configuration option.
Mode: interface isdn
Step
1 node (if-isdn)[if- name ]# call-hold
{auto|enable|disable}

Enabling Display Information Elements on ISDN Ports

By default no display information elements are sent in ISDN signaling messages. You can enable sending of
ISDN Display Information elements in ISDN signaling messages using the following command.
Mode: interface isdn

Using an alternate source IP address for specific destinations

Command
Command
Command
Purpose
Enable or disable RTP encryption support on an
IP interface.
Purpose
Defines that locally originated packets destined
for the specified destination network shall use the
IP address of the specified IP interface as their
source address.
Purpose
Enable or disable the call-hold functionality for
an isdn interface. If 'auto' is selected, call-hold is
automatically disabled on p2p links and enabled
on p2mp links.
Default: auto
25 • VPN configuration
295