Command Index Numbers - Patton electronics SmartWare R.3.20 Software Configuration Manual

SmartWare Software Configuration Guide
Mode: Administrator or operator execution
Step Command
node# who Shows more detailed information about the users ID, name, state, idle time and
1
node> who Shows the user login identity
Example: Checking identity and connected users
The following example shows how to report who is logged in or more detailed information about users and
process states, depending on the execution mode in which you are working.
Used in administrator execution mode:
node#who
ID User name
* 0 administrator
1 support
Note The "*" character identifies the user executing the
sents the ID of the account. State represents the actual running condition of
the user, which can be logout, login, exec, or config.
Used in operator execution mode:
node>who
You are operator support

Command index numbers

A command index number (indicated by the boldface 1, 2, and 3 index numbers in the example below) indi-
cates the position of a command in a list of commands (that is, a command with index 1 will appear higher in
the configuration file than one with index 3).
192.168.1.1(pf-voip)[default]#show running-config
...
profile voip default
codec 1 g711ulaw64k rx-length 20 tx-length 20
codec 2 g711alaw64k rx-length 20 tx-length 20
codec 3 g723-6k3 rx-length 30 tx-length 30
dejitter-max-delay 200
...
commands that make use of index numbers always show the index in the running config. However, the index
can be omitted when entering the command. If you enter such a command with an index, it is inserted into list
at the position defined by the index. If you enter such a command without an index, it is placed at the bottom
Accessing the SmartWare CLI task list
Purpose
location
State
exec
exec
or
Idle Location
00:00:00 172.16.224.44:1160
00:01:56 172.16.224.44:1165
command. ID repre-
who
4 • Accessing the CLI
56