Setting The Response Timeout; Setting The Connect Timeout - Patton electronics SmartWare R.3.20 Software Configuration Manual

SmartWare Software Configuration Guide
Mode: Gateway H.323
Step
1 node (gw-h323)[h323]#call-signaling-port
port
Example: Defining an alternate call-signaling port
The following example shows how to define an alternate call-signaling port on an already defined H.323 Gate-
way.
node(cfg)#gateway h323 h323
node(gw-h323)[h323]#call-signaling-port 1721

Setting the response timeout

Per default the H.323 gateway waits for 12s from the time it initiated a call towards the IP network until it ter-
minates the call, if no response has been received. This time can be changed using the following procedure:
Mode: Gateway H.323
Step
1
node (gw-h323)[h323]# timeout response
seconds
Example: Defining an alternate response timeout
The following example shows how to define an alternate response timeout of 6 seconds on an already defined
H.323 Gateway.
node(cfg)#gateway h323 h323
node(gw-h323)[h323]#timeout response 6

Setting the connect timeout

Per default the H.323 gateway waits for 60s when the call is in the alerting phase for the call to be answered. If
the call is not answered within that time, the call is dropped. The value of this timer can be changed using the
following procedure:
Mode: Gateway H.323
Step
1
node (gw-h323)[h323]# timeout connect sec-
onds
Example: Defining an alternate connect timeout
The following example shows how to define an alternate connect timeout of 20 seconds on an already defined
H.323 Gateway.
node(cfg)#gateway h323 h323
node(gw-h323)[h323]#timeout connect 20
Gateway configuration task list
Command
Command
Command
38 • H.323 gateway configuration
Purpose
Define the TCP port to use for inbound call-sig-
naling connections
Purpose
Defines the response timeout in seconds.
Purpose
Defines the connect timeout in seconds.
488